PREPARATION
Remote Control Battery Installation
The remote control operates on 2 “AAA” batteries.
1.Open the battery compartment cover
Push and pull open the battery compartment cover on the backside in the direction of the arrow, and remove the cover.
Handling the Remote Control
Use the remote control within a distance of about 5m (16’) from the front of the unit’s remote control sensor and within an angle of about 30 degrees on both sides.
2. Install the batteries
Install 2 “AAA” batteries (included) making sure the polarities match the indication inside the compartment.
3.Close the battery compartment cover
Make sure the tabs rest in the corresponding holes a n d p u s h d o w n t h e compartment cover until it clicks shut.
Within 30 | Within 30 |
degrees | degrees |
About 3m (10’) | About 3m (10’) |
| About 5m (16’) |
CAUTION
Risk of corrosion or battery leakage. Tampering with batteries may result in physical injury and/or property damage including fire.
Never mix used and new batteries in the device.
Replace all the batteries in the device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible malfunction, read the following instructions and handle the remote control correctly.
Do not drop or allow impact to affect the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet surface.
Do not place the remote control under direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
Whenever the unit is moved, two people are required to transport it safely.
Whenever the unit is moved, it should be lifted forwards by holding the top and base on both sides of the unit for stability.
17
