English
ASSEMBLY AND OPERATION
APPLICATIONS
Driving and removing of small screws, small bolts, etc.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Rechargeable battery
Fig. 3
| How to install the battery. | |
| Align the battery with the groove in tool | |
Latch | handle and slip it into place. | |
Always insert it all the way until it locks in | ||
| ||
Insert | place with a little click, If not, it may | |
accidentally fall out of the tool, causing | ||
| injury to you or someone around you. (Fig. | |
| 3) | |
Pull out | How to remove the battery. | |
Withdraw battery from the tool handle | ||
| ||
| while pressing the latch on the side of the | |
| battery. (Fig. 3) |
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
Battery
Battery installation hole
Pilot lamp
1.Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
Fig. 4
12
