English
Remove exhausted batteries from the hook immediately.
●Do not discard batteries together with normal trash and do not throw batteries into fire.
●Store batteries out of the reach of children.
●Use batteries correctly in accordance with the battery specifications and indications.
2. Installing the bit
Always follow the following procedure to install driver bit. (Fig. 13)
(1)Pull the guide sleeve back.
(2)Insert the bit into the hexagonal hole in the anvil.
(3)Release the guide sleeve and it returns to its origianl position.
CAUTION
●If the guide sleeve does not return to its original position, then the bit is not installed properly.
Movement
Driver bit
Hexagonal hole
in the anvil Guide sleeve
Fig. 13
R | Push button | L |
PushPush
Fig. 14
3.Removing the bit
Please do the opposite point on the method of installing bit.
4.Confirm that the battery is mounted correctly.
5.Check the rotational direction
The bit rotates clockwise (viewed from the rear side) by pushing the
The
CAUTION
●The push button can not be switched while the impact driver is turning. To switch the push button, stop the impact driver, then set the push button.
6. Switch operation
When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool stops.
The rotational speed can be controlled by varying the amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger switch is pulled more.
NOTE
A buzzing noise is produced when the motor is about to rotate; this is only a noise, not a machine failure.
7.Tightening and loosening screws
Install the bit that matches the screw, line up the bit in the grooves of the head of the screw, then tighten it.
Push the impact driver just enough to keep the bit fitting the head of the screw.
17
