English
TROUBLESHOOTING
|
|
|
|
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your | |||
dealer or the Hitachi Authorized Service Center. |
| ||
Symptom | Possible cause | Remedy | |
The motor won’t operate | The power plug is not plugged into the power | Plug the power cord into the power socket. | |
when the trigger is pulled. | socket. |
| |
| The switch is set at “OFF” | Switch the washer on. | |
| The extension cord is unplugged or severed | Replace the extension cord or check it with a | |
| midway. | di erent electrical appliance. | |
| The thermal protector has been activated. | Remedy the problem in accordance with the | |
|
|
| details listed in “Safety Mechanisms” on |
|
|
| page 21. |
The motor continues | The water volume or pressure from the faucet | Open the faucet fully. | |
operating when the | is too low. | Unravel any twists in the water hose and | |
trigger is released. |
|
| |
|
|
| Check to make sure that the inner diameter |
|
|
| of the water hose is correct. |
|
|
| Check to make sure that the water hose is |
|
|
| not wound onto the reel. |
| Water is leaking. | Check the hose connections. | |
Water is not being | The water hose is not connected. | Connect the water hose. | |
discharged. | The water hose or | Unravel the twists. | |
| twisted. |
| |
| The backflow valve on the | Check to make sure that the inner diameter of | |
| not operating. | the water hose is correct. | |
| The trigger stopper is locked. | Remedy the problem in accordance with the | |
|
|
| details listed in “Trigger Stopper” on page 20. |
| The faucet it turned o . | Open the faucet fully. | |
| The nozzle is blocked. | Clean the end of the nozzle with the nozzle | |
|
|
| cleaner pin supplied. |
| The strainer is blocked. | Wash the strainer, which is incorporated into | |
|
|
| the water feed inlet, in accordance with the |
|
|
| details listed in “Inspecting the Strainer” on |
|
|
| page 21. |
The water pressure won’t | The power plug is not plugged into the power | Plug the power cord into the power socket. | |
rise. | socket. |
| |
| The switch is set at “OFF”. | Switch the washer on. | |
| The water volume or pressure from the faucet | Open the faucet fully. | |
| is too low. | Unravel any twists in the water hose and | |
|
|
| |
|
|
| Check to make sure that the inner diameter |
|
|
| of the water hose is correct. |
|
|
| Check to make sure that the water hose is |
|
|
| not wound onto the reel. |
| The nozzle is blocked. | Clean the end of the nozzle with the nozzle | |
|
|
| cleaner pin supplied. |
| The electrical voltage is too low. | Check to make sure that the thickness and | |
|
|
| length of the extension cord is appropriate. |
| Water is leaking. | Check the hose connections. |
22