English
APPLICATIONS
◯Floor and wall framing.
◯Truss
◯Subflooring and roof decking.
◯Wall sheathing.
◯Mobile home and modular housing construction.
REMOVAL AND INSTALLATION METHOD OF BATTERY
◯How to install the battery
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you.
◯How to remove the battery
Withdraw battery from the tool handle while pressing
the latch on the side of the battery. Handle
Latch
Insert
Pull out
Battery
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
◯The power source voltage is stated on the nameplate.
◯The cord is not damaged.
WARNING
⬤Do not charge at voltage higher than indicated on the name plate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
⬤Do not use the electrical cord if damaged. Have it repaired immediately.
1.Insert the battery into the battery charger. Make sure it contacts the bottom of the battery charger.
2.Insert the plug of battery charger into the receptacle.
3.Charging
◯When the plug of battery charger has been inserted into the receptacle, charging will commence and the pilot lamp will light on.
NOTE: If the pilot lamp does not light, pull out the plug from the receptacle and check if the battery is properly mounted.
◯In approx. 60 min. at 70°F (20°C), when the battery is fully charged, the pilot lamp will go out.
NOTE: The battery charging time becomes longer when a temperature is low or the voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed after start of the charging, stop the charging and contact your
HITACHI AUTHORIZED SERVICE CENTER.
4. Disconnect battery charger from the receptacle.
CAUTION
Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid damaging cord.
5.Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out the battery from the battery charger.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been used for an extended period is not activated, the electric discharge might be low when using them the first and second time. This is a temporary phenomenon, and normal time required for recharging will be restored by recharging the batteries 2 – 3 times.
How to make the batteries perform longer.
◯Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery. If you continue to use the tool and exhaust the electric current, the battery may be damaged and its life will become shorter.
◯Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged immediately after use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery and recharge it after it has cooled for a while.
CAUTION
⬤When the battery charger has been continuosly used, the battery charger will be heated, thus constituting the cause of the failures. Once the charging has been completed, give 15 minutes rest until the next charging.
— 12 —
