Interlock switches prevent the machine from operating when the feed hopper is out of position or the pusher plate is raised above the feed hopper. If these features do not function as described, contact your local Hobart service office.
During operation, when the pusher plate is fully raised above the feed hopper, the machine stops and allows the pusher plate to be rotated counterclockwise for loading. To continue operation, rotate the pusher plate clockwise until it is directly above the feed hopper. As the pusher plate begins to lower into the hopper, the machine will restart — you do not need to push the green START switch unless STOP was pressed.
Always push the red STOP switch before changing cutters or cleaning.
OPERATIONS WITH A SINGLE PLATE — (Fig. 1) (Slicing, Shredding, Grating and Julienne Cutting)
1.Grasp pistol grip handle, raise pusher plate and turn to the left.
2.Release the feed hopper lock by turning the finger paddle counterclockwise. Then raise the feed hopper.
3.Remove the locking screw by turning it clockwise. Always use the wrench when removing the locking screw.
4.Lower the ejector plate on the knife shaft until the ejector plate seats on the shaft pin.
5.Select the appropriate plate for the job. Place the plate on the shaft, turning until engaged. Lock the cutting tool by turning the locking screw counterclockwise. THE LOCKING SCREW MUST ALWAYS BE USED.
6.Lower the feed head. When the pusher plate is rotated and lowered, the feed head will automatifally be locked.
OPERATIONS WITH TWO PLATES — (Fig. 2) (Dicing)
1.Raise the pusher plate and turn it to the left.
2.Release the feed hopper lock by turning the finger paddle counterclockwise. Then raise the feed hopper.
3.Remove the locking screw by turning it clockwise. Always use the wrench when removing the locking screw.
4.Lower the ejector plate on the knife shaft until the ejector plate seats on the shaft pin.
5.Select the proper size dicing plate and place it correctly on the knife shaft above the ejector plate. Select the appropriate slicing plate for the job (see Cutting Tool Guide). Place the slicing plate on the shaft, turning until engaged. Lock the cutting tool by turning the locking screw counterclockwise. THE LOCKING SCREW MUST ALWAYS BE USED.
6.Lower the feed hopper. When the pusher plate is rotated and lowered, the feed hopper will automatically be locked.
|
Fig. 1
|
Fig. 2
– 4 –
