BOWL PLACEMENT
The bowl must be installed before the agitator is installed.
To install the bowl, lower the bowl support and position bowlso the alignment pins on the left
side of the bowl support fit in the holes in the bowl tab.(Fig. 3) Place the slotted tab on bowl
into the lower part of the pin. Swing the bowlinto the mix position on bowl support. (Fig. 4)
Fig. 3
AGITATOR
Fig. 4
To install an agitator, the bowl must be on the bowlsupport.
To Inst all
1. Lower the bowl.
2. Open the bowl guard wire cage.
3. Plac e the a gitator inside the bow l and al ign the horizont al slot on the agita tor with t he agitat or
shaft pi n.
4. Slid e the a gitator up the agitator shaft until i t stops and lat ches. An audi ble cli ck shoul d be
heard when the agitator locks in position.
To Remove
1. Open the bowl guard wire cage.
2. Lower the bowl.
3. Hold the agitator and pull the plunger of the agitatorout (Fig. 5). Slide agitator down off the
agitator shaft.
Fig. 5
8