Hobart KA7E - page 6

– 6 –

Chemical Cleaner Supply and Grease Drain Connections

oven cleaners are corrosive and can

cause chemical burns. rubber gloves, goggles and

protective clothing are required. read and follow the

instructions for the oven cleaner.

P2 Chemical Cleaner Supply — Hose barb to accept 1/4"

ID chemically resistant tubing, supplied with oven.

NOTE: Use only kay chemical cIP cleaner or other

approved cleaners for proper operation. Unapproved

chemicals can cause excess foaming, poor dispensing,

poor washing, poor draining and damage to seals and

other components inside the oven. Do Not use any

chemicals in addition to the approved, self-dispensed

cleaner as hazardous interactions can result.

The amount of chemical that is self-dispensed may need

to be adjusted for various reasons, such as for light or

heavy soil or when using alternative approved cleaners.

contact Hobart service to make any needed parameter

changes to cleaning cycle programming.

Hose is 6 feet long, can be cut to suit. A #4 or #6 SST

hose clamp is recommended for the tubing at the barbed

tting.

• Cut a 45° angle on the bottom end of the tubing.

• Cut a 3/4" I.D. PVc pipe, not supplied, about 18" long,

with a 45° angle at each end.

• Put the angled end of the tubing inside the pipe

(Fig. 3) so both angled ends extend to the bottom

of the container (fig. 4). The pipe prevents the

tubing from curling inside the container and prevents

suctioning against the container bottom.

P3 Grease Drain — Hose barb to accept

1/4" ID high-temperature tubing

supplied with machine, 212°f rated.

Hose is 6 feet long, can be cut to suit. A #4 or #6 SST hose clamp is

recommended for the tubing at the barbed tting.

• Connect the grease drain tubing to the barbed tting, P3.

• Insert the other end of the grease drain tubing into a suitable

grease vessel, not supplied, similar to the one shown in

fig. 5.

Fig. 3

Fig. 4

Fig. 5