MAINTENANCE
WARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE DOING ANY MAINTENANCE.
Routinely inspect the machine to make sure that it is in proper working order. Plates must be clean, intact and sharp.
The knife shaft should be regularly lubricated with a drop of mineral oil, NOT COOKING OIL.
REPLACEMENT DICING GRIDS
Depending on usage, dicing grids become dull from wear with an average life expectancy from 8 – 18 months. Dicing grids cannot be resharpened and are therefore expendable. Replacement dicing grids are available from your local Hobart Service office.
TROUBLESHOOTING
SYMPTOM |
| POSSIBLE CAUSE | SUGGESTED ACTION |
|
|
|
|
Machine will not start. | A. | Feed cylinder not locked in correct | Make sure feed cylinger is locked |
|
| position. | correctly. |
| B. | Pusher plate or feed cylinder not | Fit pusher plate into proper operating |
|
| in proper operating position. | position. |
| C. Pusher plate swung out beside | Swing pusher plate into feed cylinder | |
|
| feed cylinder. | center. |
| D. | Fuse or circuit breaker interrupting | Check for blown fuses or fuses with |
|
| power. | wrong amperage. |
| E. | Broken wire or connection. | Pull electrical cord from receptacle |
|
|
| and call your local Hobart Service |
|
|
| Office. |
|
|
|
|
Machine stops while operating | A. | Pusher plate raised. | Swing pusher plate into feed cylinder |
and won't restart. |
|
| center and lower pusher plate. |
| B. | Fuse or circuit breaker interrupting | Check for blown fuse or fuses with |
|
| power. | wrong Amperage. |
| C. Motor overloaded and thermal | Thermal motor protection will | |
|
| motor protection has shut machine | automatically allow motor to restart |
|
| off. | when it has cooled. |
|
|
|
|
|
|
|
|
– 11 –