– 13 –
LOADING
Insert pointed end of the angle spits into left side of rotor, facing the unit (Fig. 24).
CAUTION: Do not jam angle spit into the square hub.
Insert square end of the angle spit in the square hub on the right side of the rotor (Fig. 25).
PL-41700 PL-41701
Fig. 24 Fig. 25
Ensure round end of the angle spit drops down so the square end, on the right side, is properly
held in place and fully engaged. Repeat for all angle spits (Fig. 26).
NOTE: Stagger loading. Angle spits must be loaded on alternate positions of the rotor until all positions
are loaded. When cooking a partial batch with less than seven or eight angle spits, the angle spits must
be staggered on the rotor.
Use the foot pedal to stop / start rotor rotation (Fig. 27). Load every other spit position until all
spits are in position: For example, load the first position, skip the second, load the third, skip
the forth, etc.
Close the door.
PL-41702
PL-41703
Fig. 26 Fig. 27