Hobart OM-303 manual Introduction, Symbols And Definitions, Included with Your Unit

2-2. Symbols And Definitions

Tig Welding	Remote Foot/Hand	Stick Welding	High Temperature
	Control
Output	Alternating Current	Direct Current	On
	Electrode	Do Not Switch
Electrode Positive			Voltage Input
	Negative	Under Load

A	Amperes		Off		Electrode			Gas Out
	Amperage Control/		Work		Remote		V	Volts
	Panel
U0	Rated No Load	U2	Conventional Load	X	Duty Cycle		I1eff	Maximum Effective
	Voltage (Average)		Voltage					Supply Current
I1max	Rated Maximum	I2	Rated Welding	IP	Degree Of	11	11	Single-Phase
								Combined AC/DC
	Supply Current		Current		Protection			Power Source
	Percent	U1	Primary Voltage		Line Connection		Hz	Hertz

SECTION 3 – INTRODUCTION

3-1. Included with Your Unit

			1	12 ft (3.7 m) Work Cable
				and Clamp
			2	150 Amp TIG Torch with
				12-1/2 ft (3.8 m) Cord and
				Flow-Through
				Quick-Connect (50 Hz
6	7	8		models come with 25 ft (7.6
				m) TIG Torch)
			3	Electrode Holder and
				Quick-Connect
5			4	Gas Hose
			5	Gas Regulator (Not
				included with 50 Hz
				models)
			6	“How-To” Videotape
4		1	7	RFC-14 Foot Control with
				20 ft (6 m) Cord (60 Hz
				models only. 50 Hz models
				come with RCC-14
				fingertip control instead.)
			8	8 ft (2.4 m) Primary Cord
				(Plug supplied with 230
3				Volt model only)
			. Some assembly is required.
		2
			For options and accessories see
			back of book or contact your dis-
			tributor.

OM-303 Page 10