7-3. Overload Protection (Honda-Powered Units)
1
1Ignition Circuit Breaker
The circuit breaker protects the en- gine battery charging circuit. A short circuit or a battery connected in reverse polarity will trip the circuit breaker.
Press button to reset breaker.
.If a switch or breaker opens, it usually indicates a more seri- ous problem exists. Contact a Factory Authorized Service Agent.
Ref. 802
7-4. Adjusting Engine Speed (Kohler-Powered Units)
2000 ± 150 rpm
3720 ± 50 rpm (60 Hz)
3250 ± 50 rpm (50 Hz)
Tools Needed:
After tuning engine, check engine speeds. See table for proper no load speeds. If necessary, adjust speeds as follows:
Start engine and run until warm.
Weld/Power Speed
Adjustment
1Throttle Control Lever
2Adjustment Screw
Move lever to Run (far right) posi- tion. To increase speed, turn screw out (counterclockwise) while lightly pushing lever to the right. To de- crease speed, turn screw in (clock- wise).
Idle Speed Adjustment
3 Adjustment Screw
Move lever to idle (far left) position. To increase idle speed, turn screw in (clockwise). To decrease idle speed, turn screw out (counter- clockwise).
YStop engine. Close fuel valve.
Top View
3
Top View
21
802
