Hobart Welding Products HP-25 TORCH, 250ci Torch And Work Cable Connections, Torch Connections

Models: 250ci HP-25 TORCH

1 36
Download 36 pages 19.27 Kb
Page 28
Image 28

.A complete Parts List is available at www.HobartWelders.com

6-5. Torch And Work Cable Connections

 

Y Turn Off power source, and

 

 

disconnect input power.

 

If torch or work cable needs to be

 

removed or replaced, proceed as

 

follows:

8

1

Power Source

Remove wrapper from unit.

 

 

Torch Connections

 

Remove existing torch cable from

 

unit.

 

2

Strain Relief

 

3

Torch Cable

Insert strain relief on end of cable through front panel opening. Slide

5 7 9 6 41 strain relief nut onto torch cable, but do not tighten.

4 Air Line Connector

Install air line connector onto compressor fitting.

5 Plug PLG4/Receptacle RC4

Connect PLG4 to receptacle RC4 on circuit board PC1.

32

6 7

6Female And Male Friction Terminal RC1/ELECTRODE

Connect female friction terminal on end of black lead to RC1/ELECTRODE.

7Female And Male Friction Terminal RC2/TIP

Connect female friction terminal on end of red lead to RC2/TIP.

Tighten strain relief nut.

Tighten strain relief around cable.

 

Work Cable Connections

2

Remove existing work cable from

unit.

 

8 Strain Relief

5

. Be sure to allow some work

 

 

cable slack inside the unit.

 

Insert strain relief on end of cable

 

through front panel opening. Slide

 

strain relief nut onto work cable and

 

secure strain relief to front panel.

 

9 Work Lead Male Friction

 

Terminal

 

Connect work clamp lead to male

 

friction terminal labeled WORK on

 

circuit board PC1.

 

Reinstall wrapper.

Tools Needed:

5/16 in

Ref. 804 852-B / 804 887-A

OM-230 455 Page 24

Page 28
Image 28
Hobart Welding Products HP-25 TORCH, 250ci manual Torch And Work Cable Connections, Torch Connections