Hobart Welding Products HP-25 TORCH Connecting Work Clamp, Electrical Service Guide For 120 VAC

.A complete Parts List is available at www.HobartWelders.com

4-6. Connecting Work Clamp

1	. Do not connect work clamp to
		the portion of the workpiece
		that will fall when cut.
	1	Work Clamp
	2	Workpiece
	Connect work clamp to a clean,
2	paint-free location on workpiece, as
	close to cutting area as possible.
		Ref 803 915-A
4-7. Electrical Service Guide For 120 VAC
		50/60 Hz
		Single
		Phase
Input Voltage		120
Input Amperes At Rated Output		19
Max Recommended Standard Fuse Rating In Amperes
Circuit Breaker 1, Time-Delay 2		20
Normal Operating 3		30
Min Input Conductor Size In AWG 4		12
Max Recommended Input Conductor Length In Feet (Meters)		34
		(10)
Min Grounding Conductor Size In AWG 4		12

Reference: 2005 National Electrical Code (NEC) (including article 630)

1Choose a circuit breaker with time-current curves comparable to a Time Delay Fuse.

2“Time-Delay” fuses are UL class “RK5” .

3“Normal Operating” (general purpose - no intentional delay) fuses are UL class “K5” (up to and including 60 amp), and UL class “H” ( 65 amp and above).

4Conductor data in this section specifies conductor size (excluding flexible cord or cable) between the panelboard and the equipment per NEC Table 310.16. If a flexible cord or cable is used, minimum conductor size may increase. See NEC Table 400.5(A) for flexible cord and cable requirements.

YCaution: Failure to follow these fuse and circuit breaker recommendations could create an electric shock or fire hazard. These recommendations are for a dedicated branch circuit that applies to the rated output and duty cycle of the power source.

4-8. Extension Cord Data

	Input Power
Input Voltage	Phase	Hertz	Conductor Size	Max. Cord Length
120 V	1	50/60	12 AWG	50 ft (15 m)

OM-230 455 Page 12