5-3. Description Of Controls (Honda-Powered Units) (See Section 5-2)
.Weld and auxiliary power output stops if generator overheats or engine speed is too low.
1 Engine Switch
On models with
On models with
2 Throttle Control Lever
Use lever to select engine speed. Move lever to idle position (far right) for idle speed. Move lever to Run position (far left) for weld/power speed.
.Always place lever in Run position (far left) for auxiliary power and for maximum weld output.
3 Choke Control Lever
Use lever to change engine air/fuel mix. Move
lever to left if starting a cold engine. Move le- ver to right if starting a warm engine.
4Starter Handle
To Start (Recoil): open fuel valve, turn engine switch to On, move throttle lever to Idle, set choke, and pull starter handle. Open choke as engine warms.
To Start (Electric): open fuel valve, move throttle lever to Idle, set choke, and turn en- gine switch to Start position. Open choke as engine warms.
YIf the engine does not start, let engine come to a complete stop before at- tempting restart.
To Stop: turn engine switch to Off.
.Always close fuel valve after stopping unit. Moving unit with fuel valve open may cause carburetor flooding and make starting difficult.
5 Welding Range Label
Use label to determine correct weld amper- age based on electrode size, type, and mate- rial thickness.
6 Current Control
Use control to select weld amperage. Control may be adjusted while welding.
To Set Current Control: Use label to deter- mine correct size electrode for material thick- ness. Select electrode type and set current control to corresponding amperage range on nameplate. Adjust control within selected range to obtain desired weld performance.
EXAMPLE:
Material Thickness: 1/8 to 1/4 in
Electrode Diameter: 1/8
Electrode Type:
Current Control Setting: 90 – 120 A
Notes
