Hobart Welding Products TM-944C manual Operation, Controls, Voltage Switch, Or 4-3, as applicable

SECTION 4 − OPERATION

4-1. Controls

1 Voltage Switch

The higher the selected number, the thicker the material that can be welded (see weld setting label in welding power source or Sections 4-2and 4-3, as applicable). Do not switch under load.

. Switch must “click” into detent position 1, 2, 3, 4, or purge for proper contact.

2 Voltage Switch - Purge “0” Position

In purge position, fan runs but there is no weld output.

		3	Wire Speed Control
		Use control to select a wire feed
		speed. As Voltage switch setting in-
		creases, wire speed range also in-
		creases (see weld setting label in
		welding power source or Sections
		4-2or 4-3, as applicable).
1	2	4	Power Switch

3

4

Ref. 196 082

Handler 135 / 175 Return To Table Of Contents TM-944 Page 13