Hobart Welding Products TM-944C manual Installation, Installing Welding Gun Installing Work Clamp

SECTION 3 − INSTALLATION

3-1. Installing Welding Gun

1

3-2. Installing Work Clamp

1

2

Tools Needed:

5

3/8, 7/16 in

		1	Drive Assembly
		2	Gun Securing Thumbscrew
		3	Gun End
	4	Loosen thumbscrew. Insert gun
		end through opening until it bottoms
		against drive assembly. Tighten
		thumbscrew.
		4	Gun Trigger Leads
2	3	Insert leads, one at a time, through
		gun opening on front panel.
		Connect female friction terminals to
		matching male terminals in unit.
		Polarity is not important.
		Close door.

Ref. 802 440-A

3	1	Nut
	2	Work Cable From Unit
	3	Work Clamp
	4	Screw
	5	Work Clamp Tabs

Bend tabs around work cable.

4

802 456

TM-944 Page 6 Return To Table Of Contents Handler 135 / 175