A SS E M B LY

I N S T R U C T I O N S

Step 2g

F R A M E A S S E M B L Y

In this step start by attaching (3) to (6) by sliding (34) through the mount (3), and through (35). Next slide (33) into (6) from the top down until the locating boss snaps into the location hole. Make sure (35) ends are pointing down to ensure that (3) locks (4). Attach (12) and (13) to (4) then slide (4) into (6). Once (4) is in (6) insert (32) to (4). Finally attach (41), (10) and (40), (11) to (6) as shown. Wrench tighten bolts.

Part Descriptions

3 - Latch Assy.

4- Mid-Chest Chrome Adjuster

6- Arm Rest Assy.

10 - Right Arm Upholstery Assy.

11 - Left Arm Upholstery Assy.

12- Mid-Chest Upholstery Assy.

13- Mid-Chest Upholstery Backing

32- 1 1/2” x 3 1/2” End Cap

33- EZ Glide Sleeve

34- 1.55 x .25 dia. Shaft

35- Adjuster Spring

40- Left Hand Upholstery Backing

41- Right Hand Upholstery Backing

Hardware Descriptions

H - 5/16-18 x 3 ¾” Hex Head Bolt

J - 5/16-18 x 1 ¼” Button Head Screw N - Square Head Set Screw

AF - 5/16” Internal Lock Washer AL - 5/16” Flat Washer

CJ - C-Clip

Page 17

HOIST

FITNESS SYSTEMS

R

2412 Assembly

Page 18
Image 18
Hoist Fitness CL-2412 owner manual Hardware Descriptions