Holman N10372 Manual Operations, Set Station Run Times. Continued, System Test Facility

Models: N10372

1 15
Download 15 pages 35.53 Kb
Page 7
Image 7
Step 3. Set Station Run Times. (Continued)

Programming

Step 3. Set Station Run Times. (Continued)

To adjust the Run time in minutes press next , and use

Manual Operations or System Test Facility . To set the run time in hours, press next and “0” will appear and flash. To adjust use (This is a dual function position) or Run A Single Station.

If not required, press next and advance to station 2 by pressing the Manual background button.

Continue until all the stations in Program 1 have been set with a run time, or if a station (or stations) are not required to be active in this particular program, ensure that the run time is set to “OFF”.

Note: To set a station to “OFF”.

Use Manual background when the “RUN TIME” is flashing.

This completes the setting up procedure for automatic watering of Program 1.

Should you need a second program.

Turn the dial to “Set Start Times” and “Prog 1” will flash. Press Manual background and change to program 2 position and follow the same 3 steps to set an automatic watering program.

1.Set Starts

2.Set Watering Days

3.Set Station Run Times

Tip: Remember to return the dial to the “Auto Run” position after completing the set up of an automatic program.

This will ensure that the automatic cycles will take place.

PAGE 10

Manual Operations

System Test Facility

Turn the dial to System Test or Run Single Station.

(This is a dual function position)

The display will show:

Use this feature to go & check that

your valves & sprinklers are working correctly. The unit will run all stations in sequential order. The factory preset time of 2 minutes per station can NOT be adjusted.

IMPORTANT TIP: If the water supply is from a pump system, it is critical to ensure all outputs are connected to a valve. Any output NOT connected to a valve, should be linked back with a wire to the nearest output with a valve.

This prevents the pump running against a closed head.

Run A Single Station

Turn the dial to System Test or Run Single Station.

(This will be in the system test mode) To manually run a single station once,

press Manual background button to kick the unit into the

other mode. The display will change from 2 minutes to 10 minutes.

To adjust the run time, use Manual background or Manual background .

To advance to the next station press

the next button.

PAGE 11

Page 7
Image 7
Holman N10372 Manual Operations, Set Station Run Times. Continued, System Test Facility, Run A Single Station, Programming