HoMedics BPA-300 Potential for RADIO/TELEVISION Interference, Troubleshooting, For USA only

BPA-300-A.qxd 10/5/06 4:20 PM Page 29

POTENTIAL FOR RADIO/TELEVISION

INTERFERENCE

For USA only:

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the product on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the product and the receiver.

•Connect the product into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

For Canada only:

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Canadian Department of Communications.

Cet appareil numérique respecte les limites de bruits radioeléctriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, ICES-003 édictée par le ministre des communications.

TROUBLESHOOTING

If any abnormality arises during use, please check the following points

SYMPTOMS	POSSIBLE	CORRECTION
	CAUSES
Unit does not turn on	Batteries have	Replace them with
when the	run down.	four new AA alkaline
START/STOP		batteries.
button is pushed.
	Battery polarities	Re-insert the batteries
	have been positioned	in the correct
	incorrectly.	positions.
EE measurement	Cuff has been placed	Wrap the cuff
error symbol shown	incorrectly.	properly so that it is
on display or the		positioned correctly.
blood pressure value
	Did you talk or move	Measure again.
is displayed	during measurement?	Keep arm steady
excessively low		during measurement.
	Shaking of the arm
(or high).	with the cuff on.
E1 error symbol	Air circuit abnormality.	Check cuff connection.
shown on display	Cuff tube may not be	Measure again.
	plugged into monitor
	correctly.
E2 error symbol	Inflation pressure	Turn the unit off, then
shown on display	exceeding 300 mmHg.	measure again.
E3 error symbol	Data error.	Remove and reload
shown on display		the batteries.
CA appears on	Recalibration alert.	Refer to page 26 for
display		more information.

Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page.

29 30