BPA-300-A.qxd 10/5/06 4:20 PM Page 11
INSTALLING BATTERIES
Note: It is recommended that you use batteries only for travelling or when it is not possible to use the AC adapter.
1.Extend the tray so that the battery cover is fully exposed.
2.Press down on latch and lift the battery cover towards you to open the battery compartment.
3.Install or replace 4 “AA” sized batteries in the battery compartment according to the indications inside the compartment.
4.Replace the battery cover by clicking in the bottom hooks first, then push in the top end of
the battery door.
Battery
Cover
Tray
Replace the batteries if:
1.The weak battery symbol appears on the display.
2.Nothing appears on the display when the power is switched on.
As the supplied batteries are for test only, they may be discharged earlier than batteries you buy in stores. Replace the batteries in pairs. Remove batteries when unit is not in use for extended periods of time.
Note: Batteries are hazardous waste. Do not dispose of them together with the household garbage.
USING THE AC ADAPTER
Note: • Please unload the batteries when operating with the AC adapter for an extended period of time. Leaving the batteries in the compart- ment for a long time may cause leakage, which may lead to damage of the unit.
•No batteries are needed when operating with the AC adapter.
1.Connect the AC adapter with the AC adapter jack in the back of the unit as shown below.
2.Please use only the AC adapter included with this monitor.
AC Adapter
Input: 120V 60Hz 15W
Output: 12V DC 600mA
Connect AC |
adapter here |
11 | 12 |
