Installing Instructions |
| |
1. Remove demineralization cartridge from packaging and |
| |
let it soak in water for 10 minutes. |
| |
2. Remove the tank from humidifier base. (Fig. 3) |
| |
3. Place 1 demineralization cartridge down into left | Fig. 8 | |
side matching slot in the humidifier base. (Fig 9) | ||
| ||
4. Place the tank back on the base, making sure the tank is |
|
firmly seated. (Fig. 7)
Cleaning and Care |
|
CAUTION: Before cleaning the unit, turn power off and | Fig. 9 |
unplug unit from the outlet. |
|
Troubleshooting
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Power Light is off | • Unit is not plugged in | • Plug unit in |
|
| • Press the POWER button |
|
| to turn the power on |
| • No power at unit | • Check circuits, fuses, try a |
|
| different outlet |
|
|
|
SoundSpa will not | • Unit is not plugged in | • Plug unit in |
turn on | • Volume is down too low | • Turn the SOUNDSPA |
|
| POWER/VOLUME knob |
|
| clockwise to increase |
|
| volume |
| • No sound selection has | • Press a sound selection |
| been made | button to choose a sound |
Fig.10
Fig.11
Tank Cleaning
Remove the water tank from the humidifier base by lifting it by the handle from the main unit. Unscrew the tank cap; wipe the tank with a soft cloth then rinse it with clean water. (Fig. 10)
Suggestion: Clean the water tank once every two to three weeks, depending on your water conditions.
Ultrasonic Nebulizer Cleaning
Put small amount of mild dish soap on the surface of the ultrasonic nebulizer, then pour in some water and soak for 5 minutes. Brush clean with soft bristle brush (not included) and rinse. (Fig. 11)
Surface Cleaning
Clean the surface of the unit with a clean damp soft cloth. (Fig. 12)
| • Sleep Mode cycle is over | • Use the SOUNDSPA |
|
| POWER/VOLUME knob to |
|
| turn the SoundSpa OFF, |
|
| then back ON again. |
|
|
|
Peculiar Odor | • If new unit | • Open the water tank cap |
|
| and keep it in a shady and |
|
| cool place for 12 hours |
| • If unit is in use, the odor | • Empty the old water, |
| may be a dirty tank or old | clean the tank and fill |
| tank water | with clean water |
|
|
|
Excessive Noise | • Unit is not level | • Place unit on a flat, |
|
| even surface |
| • Low water level | • Check the water level. Refill |
|
| the tank if the water is low |
|
|
|
White Dust Accumulation | • Hard water used | • Use distilled water and a |
|
| Demineralization Cartridge |
| • Demineralization Cartridge | • Replace Demineralization |
| needs replacement | Cartridge |
Fig.12
10
11