Blade Lever (Adjustable Taper Control)
•The lever is conveniently located near your thumb (if you’re right- handed) so it can easily be adjusted while the clipper is in your hand.
•The lever adds versatility to your clipper by allowing you to gradu- ally change the closeness of your cut without an attachment comb.
•When the lever is in the uppermost position, the blades will give you the closest cut and leave the hair very short. Pushing the lever downward gradually increases the cutting length.
•In its lowest position, the lever will leave the hair approximately 1/8 inch length.
•The lever will also extend the use of your blades since a different cutting edge is used in each setting.
•In addition, if extremely heavy hair cutting has jammed the blades, it will help you remove hair that has become wedged between the two blades without removing the blades.
•While the clipper is running, rapidly move the lever from ”close cut” to “longer cut” a couple of times.
Doing this each time after you have finished using your clipper will help to keep the blades clear of cut hair. If your clipper stops cutting and this does not help, your cutting blades are dulled. Replace them with new blades.
Attachment Comb (see below)
•Attachment Comb #1 leaves 1/8 inch (3mm) hair length
•Attachment Comb #2 leaves 1/4 inch (6mm) hair length
•Attachment Comb #3 leaves 3/8 inch (9mm) hair length
•Attachment Comb #4 leaves 1/2 inch (12mm) hair length
•Left Ear Taper Attachment Comb
•Right Ear Taper Attachment Comb
Each comb attachment is marked accordingly on its outside middle surface and color coded.
•To attach a comb, hold it with its teeth upward and slide it onto and along the clipper blade until the front of the comb firmly sits against the clipper blade.
•To remove the comb, simply pull the comb upward and away from the clipper blade.
•For even cutting, allow the comb attachment cutter to cut its way through the hair. Do not force it through quickly. Also remember to comb the hair frequently to remove trimmed hair and to check for uneven strands.
#1 (1/8" 3mm)
#2 (1/4" 6mm) | #3 (3/8" 9mm) |
|
#4 (1/2" 12mm) | LEFT TAPER | RIGHT TAPER |
9
8
