If your unit has been preassembled, check each step to | FRONT HANDLE |
make sure the unit has been properly assembled. |
1.Remove the front handle, bolt, and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown, then install the wing nut.
4.Tighten wing nut securely.
CURVED SHAFT GRASS DEFLECTOR WITH- OUT EDGER GUIDE - TRIMLITE AND TRIM ‘N EDGE
See Figure 3.
1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place curved shaft grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflector and bracket on shaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten Securely.
See Figure 4.
1.Assemble the two plastic pieces of the edger guide together using the short bolt, flat washer, lock washer and wing nut.
2.Slide the edger guide to adjust it to the desired trim- ming length.
3.Tighten the wing nut securely.
Page
BOLT
BRACKET
EDGER GUIDE
PIECES
WASHER
Fig. 2
DEFLECTOR
LOCK WASHER
WING NUT | Fig. 3 |
|
LOCK
WASHER
FLAT WASHER
SHORT BOLT
Fig. 4