ASSEMBLY
CURVED SHAFT GRASS DEFLECTOR WITH EDGER GUIDE - TRIM ‘N EDGE ONLY
See Figures 5 and 6.
1.Remove the wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place the curved shaft grass deflector over the shaft and bracket.
3.Slide the assembled edger guide over the tabs on the grass deflector and bracket.
4.Place the bolt through the slots in the tabs on the grass deflector and trimmer.
NOTE: Ensure the slots are aligned before installing the bolt.
5.Install the flat washer, lock washer and wing nut.
6.Tighten the wing nut securely.
STRAIGHT SHAFT GRASS DEFLECTOR - EASY REACH
See Figure 7.
1.Remove the wing nut and clamp from the grass deflec- tor.
2.Assemble straight shaft grass deflector to drive shaft so that the peg in the grass deflector fits in the locator hole in the lower side of the drive shaft near the gear head.
3.Place the mounting bracket over the drive shaft so the square tab on the mounting bracket fits into the slot in the straight shaft grass deflector.
4.Rotate the mounting bracket so the screw on the grass deflector goes into the slot on the mounting bracket.
5.Install the wing nut and tighten securely.
ASSEMBLED
EDGER GUIDE
WING NUT
LOCK
WASHER
FLAT
WASHER
TABS
Fig. 5
LONG BOLT
Fig. 6
WING NUT | LOCATOR |
|
MOUNTING | DRIVE | |
BRACKET | HOLE | |
|
| SHAFT |
GEAR
HEAD
| LOCATOR |
SLOT | PIN |
| |
SCREW |
|
GRASS DEFLECTOR | Fig. 7 |
|
Page
