OPERATION
Trimmer should be on a flat, bare surface for starting.
1.Slowly press the primer bulb seven (7) times.
2.Set the choke lever to the FULL CHOKE position (A).
3.Squeeze the throttle trigger fully and pull starter handle sharply until engine attempts to run. Do not pull the starter handle more than eight (8) times.
NOTE: Keep throttle trigger squeezed fully through STEP 6.
4.Set the choke lever to the HALF CHOKE position (B).
5.Pull the starter handle until the engine runs. Do not pull the starter handle more than six (6) times.
6.Allow the engine to run for 15 seconds, then set the choke lever to the RUN position (C).
See Figure 13.
To stop the engine, push and hold the STOP button until the engine stops.
Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have.
Page 15
PRIMER BULB
C
B
A
STOP
STARTINGINSTRUCTION
LABEL
THROTTLE
TRIGGER
Fig. 12
PRIMER BULBCHOKE LEVER
RUN (C)
C |
|
B |
|
A | HALF |
| |
| CHOKE |
ST | (B) |
OP |
|
| FULL |
| CHOKE |
| (A) |
Fig. 13