MAINTENANCE
■ Remove the spark arrestor from the muffler.
■ If your spark arrestor is made of a fiberglass material, discard and replace.
■ If your spark arrestor is made of a metal material follow these cleaning instructions:
1. Spray the spark arrestor with a quality carbon cleaner.
2. Gently clean using a wire brush.
3.Install the new or cleaned spark arrestor and reassemble completely before use.
For proper performance and long life, keep air filter clean.
1. Remove the air filter cover by pushing down on the latch with your thumb while gently pulling on the cover.
2. Remove the filter, clean it in warm soapy water. Rinse and let dry completely. For best performance, replace annually.
3. Install the filter, align tabs, push in, and make sure the latch snaps and latches into place.
WARNING:
A leaking fuel cap is a fire hazard and must be replaced immediately.
The fuel cap contains a
This engine uses a NGK # BPMR7A spark plug with
.025 in. (0.63 mm) electrode gap. Use an exact re- placement and replace annually, or more frequently if necessary.
LONGER)
1.Drain all fuel from tank into a container approved for gasoline. Run engine until it stops.
2.Clean all foreign material from the trimmer. Store it in a
3.Abide by all Federal and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other
Page 18
C
B
A
STOP
TO OPEN
Fig. 20
2 |
1
STOP
COVER
S
T
O
P
A
B | C |
Fig. 21