Homelite UT20002 String Replacement, Cleaning The Exhaust Port And Muf- Fler, Spark Arrestor

Models: UT20003 UT20023 UT20022 UT20023A UT20042 UT20002A UT20002 UT20022A UT20042A UT20043A UT20003A UT20043

1 24
Download 24 pages 47.36 Kb
Page 17
Image 17

MAINTENANCE

STRING REPLACEMENT

See Figures 16, 17, 18 and 19.

1.Stop the engine, disconnect the spark plug wire. Hold the string head and unscrew the spool retainer.

To remove the spool retainer:

Turn the spool retainer counterclockwise for Trimlite and Trim n’ Edge.

Turn the spool retainer clockwise for Easy Reach.

2.Remove the spool from the string head. NOTE: Keep the spring attached to the spool. Remove any old string remaining on the spool.

3.Cut two pieces of string, each being approximately 9 ft. (2.7 m) long. Use only .080 in. (2.0 mm) diameter monofilament string.

4.Insert the first string into the anchor hole in the upper part of the spool. Wind the first string around the upper part of the spool counterclockwise, as shown by the arrows on the spool. Place string in the slot on upper spool flange, leaving about 6 in. (152 mm) extended beyond the slot. Do not overfill. After winding the string, there should be at least 1/4 in. (6 mm) between the wound string and the outside edge of the spool.

5.Repeat above step with second string, using the bottom part of spool. Do not overfill.

6.Replace the spool and the spool retainer. Refer to “Spool Replacement” earlier in this manual.

SPOOL

SPRING

ARROWS ON

SPOOL

ANCHOR

HOLE

FIRST STRING

Fig. 16

FIRST STRING

SLOT

Fig. 17

CLEANING THE EXHAUST PORT AND MUF- FLER

NOTE: Depending on the type of fuel used, the type and amount of oil used, and/or your operating conditions, the exhaust port and muffler may become blocked with carbon deposits. If you notice a power loss with your gas powered tool, you may need to remove these deposits to restore performance. We highly recommended that only qualified service technicians perform this service.

SPARK ARRESTOR

The spark arrestor must be cleaned or replaced every 25 hours or yearly to ensure proper performance of your product. Spark arrestors may be in different locations depending on the model purchased. Please contact your nearest service dealer for the location of the spark arres- tor for your model.

SECOND

STRING

Fig. 18

SLOT

ARROWS ON

 

SPOOL

Fig. 19

Page 17

Page 17
Image 17
Homelite UT20002 String Replacement, Cleaning The Exhaust Port And Muf- Fler, Spark Arrestor, Maintenance, First String