MAINTENANCE
TIGHTEN 3/4
A TURN
Fig. 70
MOUNTING THE SAFE-T-TIP® NOSE GUARD
See Figures 69 and 70.
1.Mount the
2.Fit the locking rivet or tab in the recessed hole in the guide bar.
3.Tighten the screw with your finger.
4.From the finger tight position, tighten the screw an additional
CLEANING THE AIR FILTER
See Figures 71, 72 and 73.
NOTE: Always clean the air filter before making any mixture adjustments of the carburettor.
1.For access to the air filter and carburettor area, loosen the three screws holding the cylinder cover.
2.Activate chain brake.
3.Lift the front of the cylinder cover past chain brake lever.
4.Lift the back of the cylinder cover past the handle.
5.Before removing the air filter from the carburettor, blow or brush as much loose dirt and sawdust from round the carburettor and chamber as possible.
NOTE: Be sure to pull the choke rod out to keep the carburettor from being contaminated.
6.Remove the screw securing the air filter.
7.Position a flat screw driver between the tabs and twist as shown in the illustration.
8.Lift the air filter off the air filter base.
Choose one of the following cleaning options:
9.To lightly clean, tap the filter against a smooth, flat surface to dislodge most saw dust and dirt particles.
10.For a more thorough cleaning, clean in warm soapy water, rinse, and let dry completely.
NOTE: An alternative method is to clean the filter with compressed air (always wear eye protection to avoid eye injury).
11.Reinstall the air filter, making sure that the tabs on the air filter are located in channels on the air filter bottom before tightening filter retainer screw.
Clean the
NOTE: If you use an air hose for drying, blow through both sides of filter.
CAUTION:
Never run the engine without the air filter, serious damage could result.
Make sure the air filter is correctly placed in the air filter cover before reassembly.
CYLINDER COVER
SCREW
SCREWS
Fig. 71
AIR FILTER
AIR FILTER
RETAINING
SCREW
Fig. 72
FAN
HOUSING
BAFFLE
STARTER ASSEMBLY
Fig. 73
UK - Page 33
