MAINTENANCE
CLEANING THE SPARK ARRESTING SI- LENCER
The silencer is equipped with a spark arrester screen. A faulty spark arrester screen can create a fire hazard. Through normal use the screen becomes dirty and should be inspected weekly and cleaned as required. Always keep the silencer and spark arrester on your saw in good condition.
WARNING
Silencer surfaces are very hot during and after operation of the chainsaw: keep all body parts away from the silencer. Serious burns may occur if contact is made with the silencer.
1.Allow the silencer to cool.
2.The spark arrester screen is retained by the deflector. Remove the three nuts and screen retainer to access the spark arrester screen.
3.Replace the spark arrester screen if it is cracked or otherwise deteriorated.
SPARK ARRESTER
SCREEN
DEFLECTOR SILENCER
DEFLECTOR
RETAINING
SCREW
NUTS
Fig. 79
CHAIN BRAKE
Remove the clutch cover and clean the chain brake components. Check wear on the brake band and replace if worn or deformed. The band thickness should not be less than 0.60 mm (0.024 in.), or worn halfway through.
Always keep the chain brake mechanism clean and lightly lubricate the linkage.
Always test the chain brake performance after servicing or cleaning. Refer to “Operation - Operating Chain Brake” earlier in this manual for additional information.
Check and, if damaged, replace the chain catcher.
CHAIN CATCHER
BRAKE BAND
Fig. 80
CLEAN THE CHAIN BRAKE | LUBRICATE THE CHAIN | |
BRAKE LINKAGE | ||
|
Fig. 81
STORING THE CHAINSAW (1 MONTH OR LONGER)
1.Drain all fuel from tank into a container approved for petrol.
2.Run the engine until it stops. This will remove all
3.Drain all bar and chain oil from tank into a container approved for oil.
4.Clean all foreign material from the saw.
5.Store it in a well ventilated place that is inaccessible to children.
NOTE: Keep away from corrosive agents such as garden chemicals and
Abide by all regulations for the safe storage and handling of petrol. Excess fuel should be used in other
UK - Page 35
