![RESTORE ORIGINAL](/images/new-backgrounds/89508/8950863x1.webp)
MAINTENANCE
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
Fig. 67
MAINTAINING THE GUIDE BAR
See Figure 68.
CAUTION:
Make sure the chain has stopped before you do any work on the saw.
Every week of use, reverse the guide bar on the saw to distribute the wear for maximum bar life. The bar should be cleaned every day of use and checked for wear
and damage.
Feathering or burring of the bar rails is a normal process of bar wear. Such faults should be smoothed with a file as soon as they occur.
A bar with any of the following faults should be replaced:
Wear inside the bar rails which permits the chain to lie over sideways
Bent guide bar Cracked or broken rails Spread rails
In addition, lubricate guide bars (with a sprocket at their tip) weekly. Using a grease syringe, lubricate weekly in the lubricating hole.
Turn the guide bar and check that the lubrication holes and chain groove are free from impurities.
LUBRICATING HOLE
Fig. 68
MAINTAINING THE SAFE-T-TIP NOSE GUARD
See Figures 69 and 70.
CAUTION:
Make sure the chain has stopped before you do any work on the saw.
WARNING:
Although the guide bar comes with a
Tighten the mounting screw of the nose guard as instructed below. These are specially hardened screws. If you cannot install the screw tightly, replace both the screw and the
In addition to preventing chain contact with solid objects at the nose of the bar, the
The mounting screw requires a 5/16 in. spanner (or adjustable spanner) to achieve the recommended tightness of
1.Tighten the screw with your finger.
2.Tighten the screw an additional
MOUNTING
SCREW
Fig. 69
UK - Page 32