Homelite UT74121A manual Push And Pull, Maintenance Precautions, Kick-Back, Pull Push, UK - Page

SPECIFIC SAFETY RULES

PUSH AND PULL

The reaction force is always opposite to the direction the chain is moving. Thus, the operator must be ready to control the PULL when cutting on the bottom edge of the bar and the PUSH when cutting along the top edge.

PULL

PUSH

Fig. 1

NOTE: Your chainsaw has been fully factory tested. It is normal to find some slight oil residue on the saw.

MAINTENANCE PRECAUTIONS

Never operate a chainsaw that is damaged, improperly adjusted, or is not completely and securely assembled. Be sure that the saw chain stops moving when the throttle control trigger is released. If the saw chain moves at idling speed, the carburettor may need adjusting. Refer to “Operation-Adjusting Idling Speed” later in this manual.

If the saw chain still moves at idling speed after adjustment has been made, contact a Homelite service dealer for adjustment and discontinue use until the repair is made.

WARNING:

All chainsaw service, other than items in the operator’s manual maintenance instructions, should be performed by competent chainsaw service personnel. If improper tools are used to remove the flywheel or clutch, or if an improper tool is used to hold the flywheel in order to remove the clutch, structural damage to the flywheel may occur and subsequently cause the flywheel to burst with possible serious injury.

KICK-BACK

Kick-back is a dangerous reaction that can lead to serious injury. Do not rely only on the safety devices provided with your saw. As a chainsaw user, you must take special safety precautions to help keep cutting jobs free from accident or injury.

NOTE: Refer to “Operation” later in this manual for added information on kick-back and how to avoid serious personal injury.

UK - Page 6