10. MAINTENANCE
Propeller
ECIAL SPLINE WASHER
PROPELLER
I THRUST WASHER
MARINE GREASE
45i!i
If the propeller is damaged, replace it
as follows:
Removal:
Hand tighten the castle nut until the 4
Remove the cotter pin then remove the
16 mm castle nut, 17 mm plain
mm cotter pin can be installed. If
washer, 10 mm special spline washer,
necessary, tighten the castle nut just
propeller and thrust washer.
enough to align the hole with the groove
in the nut.
COTTER PIN (stainless)
Installation:
Install
the thrust washer with the
grooved side toward the gear case, then
install the new propeller in the reverse
sequence of removal.
Use a new genuine Honda cotter pin
and bend the cotter pin ends as shown.
91