31
SERVICING YOUR TILLER
ENGINE OIL CHANGE
UPPER LIMIT
LOWERLIMIT
DRAIN PLUG
ENGINEOIL FILLER CAP/DIPSTICK
Drain the oil while the engine is warm to assure rapid and complete
draining.
Place a suitable container below the engine to catch the used oil,
and then remove the engine oil filler cap/dipstick, drain plug, and
sealing washer.
With the tiller in a level position, fill with the recommended oil to the
outer edge of the oil filter hole (see page ).
Allow the used oil to drain completely, and then reinstall the drain
plug and sealing washer. Tighten the plug securely.
Running the engine with a low oil level is misuse and can cause
engine damage. This type of damage is not covered by the
Distributor’s Limited Warranty.
Screw in the engine oil filler cap/dipstick securely.
Improper disposal of engine oil can be harmful to the environment.
If you change your own oil, please dispose of the used oil properly.
Put it in a sealed container and take it to a recycling center. Do not
throw it in the trash, pour it on the ground, or pour it down a drain.
1.
2.
3.
4.
32
07/12/21 13:27:29 31V20610_032