35
SERVICING YOUR TILLER
Paper element:
Foam element:
AIR CLEANER COVER
WINGNUT
GROMMET
5 16.5 mm
PANSCREW(5)
WINGNUT
PAPER
ELEMENT
FOAM
ELEMENT
GROOVE
TAB
PRE-AIR
CLEANER
GUIDE
PRE-AIR
CLEANERCASE
PRE-AIR
CLEANER
CASE
COVER
Tap the filter element several times to remove dirt or
blow compressed air not exceeding 30 psi (207 kPa, 2.1 kgf/cm )
through the filter from the clean side that faces the engine. Never try
to brush off dirt; brushing will force dirt into the fibers.
Install the foam element onto the paper element.
Clean both filter elements if they are to be reused.
Clean the air cleaner
cover and case.
Assemble the pre-air
cleaner case and guide
by aligning the tab of
thecasewiththe
groove of the case
cover.
Removethefive5
16.5 mm pan screws,
and remove the pre-air
cleaner guide and case.
Wipe dirt from the
inside of the air cleaner
cover using a moist rag.
Clean in warm soapy water, rinse and allow to dry
thoroughly, or clean with a high flash point solvent and allow to dry.
Dip the element in clean engine oil and squeeze out all the excess oil.
Excess oil will restrict air flow through the foam element and may
cause the exhaust to smoke when the engine starts.
Reinstall the filter
elements and grommet,
and tighten the wing
nut. Install the air
cleaner cover, and
tighten the wing nut.
5.
6.
7.
4.
3
07/12/21 13:27:59 31V20610_036