Honda Power Equipment QH4000 manual LIELMSCHfl!!ISM

----------IMPORTANT:Before beginning	assembly of	t h i s	subframe, make sure	t r a c t o r i s on a
level surface, parking brake	is set and	t h a t	engine i s turned o f f ,	with key removed.

su~ERAME-PREP_ARAILoN

a)Loosely attach rear h i t c h p l a t e (fig . 1, item 1) t o bottom of subframe channel (fig . 1, item 2).

Use a 1/2" x 1 1/4" b o l t (fig . 1, item 31, flatwasher, lockwasher and nut, and

a 1/2" x 5" b o l t , long tube spacer ( f i g . 1, item 101, lockwasher and nut (fig . 1, item 4 ) . Do not t i g h t e n yet.

b)Loosely attach subframe f l a t b a r s (fig.1,

item 5 ) and t h e lift support brackets (fig . 1, item 6) t o the sides of channel (fig.1, item 2) .

Use four	1/2" x 1 1/2"	b o l t s	(fig.1,
item 71,	lockwashers and	nuts.	Do not	FIGURE 1
tighten	yet.

c ) Loosely attach the support p l a t e (fig.1, item 8 ) i n s i d e the subframe f l a t b a r s ( f i g . 1 , item 5 ) .

Use four 318" x 1 1/4" b o l t s (fig.1, i t e m 91, lockwashers and nuts. Do not t i g h t e n yet.

LIELMSCHfl!!ISM

a) I n s e r t	two 3/8" x		2 1/4"	b o l t s (fig.2,
item	1)	through	the smaller		holes i n
the lift		lever	( f i g . 2 ,	item	21, and

secure them with a 3/8" uni- torque (stover) self - locking nuts.DC1 NOT E M D THE LEVER.

b)Attach push arm (fig.2, item 3) t o the lift lever (fig . 2, item 2) with a 17/32"

x2 1/4" p i n (fig.2, item 4) as shown.

BE SURE TO USE THE CMiRECT HOLE.

Use a 5/32" x 1" c o t t e r p i n t o secure the p i n (fig . 2, item 4) .

FIGURE 2

OM 0149 3