Honda Power Equipment QH4000 manual Bearing

Thread the adjustment f o r k (fig . 2, item 5 ) i n t o the end of the push arm (fig.2, item 3 ) . Adjust the overall length of push arm assembly t o 32 13/16".

Place an 11/16" f latwasher and a bent retainer p l a t e (fig . 2, item 6 ) on the 5 / 8 "

x4" b o l t (fig . 2, item 7 ) .

Insert the b o l t i n t o the lever as shown. Place another bent r e t a i n e r p l a t e and flatwasher on the b o l t , and secure it loosely with a lockwasher and nut.

I n s t a l l a flange bearing (fig . 3, item

1)i n t o each lift support bracket (fig . 3,

it e m 2 ) from the inside .

I n s e r t the lift arm (fig . 3, item 3) through

the bearing i n the r i g h t hand lift FIGURE 3 support bracket. Put a tube spacer

(fig . 3, item 4) on the arm, and then i n s e r t the arm through. the lift lever (under the 5 / 8 " bo1t)

I n s e r t the arm through another tube spacer, and then through the l e f t hand l i f t support bracket bearing. The end of the arm should protrude 2 1/4" beyond

the bearing.

Position the subframe channel (fig . 1, item 2) i n l i n e with subframe f l a t b a r s ( f i g . 1, item 5 ) and securely t i g h t e n b o l t s (fig . 1, item 7 and 9).

Rotate the lift arm (fig . 4, item 3) so

t h a t i t s handle i s p a r a l l e l t o the ground, and block i n t h a t position . Set the l i f t lever (fig . 4, item 2 ) so that the 5/8" x 4" b o l t ( f i g . 4 , item 4) is

perpendicular t o the ground, and then t i g h t e n the b o l t t o 50 lbs . ft .

I n s t a l l 1" x 4 1/2" p l a s t i c handle (fig.4, item 3) on lift arm (fig . 4, item 1).

4