Kenmore 116.35913, 116.35912 owner manual Motor Safety Filter

TO REPLACE DUST BIN LID

Replace dust bin lid assembly by placing back on dust bin with marks on the lid aligned as shown under Open (For EmpO#ng) on the back of the dust bin.

Turn This Dire€lion
To Close For Use	Open
	(For Emptying)

Rotate clockwise while pressing downward so marks align as shown above C/osed (For Use),

Insert dust bin

into cleaner.

Lower the dust bin handle to

lock dust bin in Handle

place.

Anoticeable "click" should be heard.

Closed

(For Use)

ElectricalShock Hazard

Unplug power cord from electrical out- let. Do not operate the vacuum clean- er withoutthe motor safety filter. Be sure the filter is dry and properly ir_-talledto prevent motor failure and/or electrical shock.

1, To remove motor safety filter lift filter release handle upward and rotate the filter cover out,

2.Remove filter by pressing on the sides of the filter frame and pulling out at the same time.

Frame

MOTOR SAFETY FILTER

Check motor safety filter frequently and clean when dirty.

I

S.

Release

/ Handle

<

Cover

Tabs

3. Clean filter if necessary by placing it under running water wait until dry before replacing.

4.When putting the filter back into the filter cover, listen for the filter assembly to snap into place.

Note: Push only on frame, not filter itself.

5.Replace cover by fitting bottom tabs into slots and rotating into compartment. Push filter release handle down until you hear a noticeable "click",

16