| Igiven. WARNING statements alert you to such dangers as fire, electric shock, burns_ | |||
_ | Please pay special attention to these hazard | alert | boxes, and follow any instructions I | |
| land personal injury. | CAUTION statements | you to such dangerous personall | |
| linjuryand/or property | damage. |
| I |
Electrical Shock Hazard
Do not plug intothe electricalsupply
until the assembly is complete. Failure to do so could result in electrical shock
or inju_.
Before assembling the vacuum cleaner, check the PACKING LIST on the cover of
the separate REPAIR PARTS LIST. Use this list to verify that you have received all
the components of your new Kenmore vacuum cleaner.
Do not over tighten,
Over tighteningcould strip the han- dle screw hole.
Do not operate the vacuum cleaner without the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord hook is in the upright position. Remove the wire tie from the power cord.
Make sure the
HANDLE ASSEMBLY
Remove the handle screw from the body of the vacuum.
Remove the combination brush from the
handle to expose the handle mounting hole.
Position the handle assembly as shown in the illustration below.
When installing the handle, firmly press the handle onto the body. Secure with handle screw provided.
Begin to tighten the screw with your fin- gers. It may be necessary to adjust the handle slightly.
Using a screwdriver, tighten handle screw.
Reinstall combination brush,
Electrical
Connection
Assembly
Handle
Screw
power cord is |
|
placed into the lock- | Notch |
ing notch on the |
|
body as shown. This |
|
helps keep the |
|
power cord out from | Power |
under the vacuum |
|
cleaner agitator. |
|
Release
Cord Hook
CordPlug
Carrying
Handle_
Wrap the power cord around the quick release cord hook and the carrying handle.
Lock the power cord plug onto the power cord.
5
