MAINTENANCE
1. Position diaphragm between connecting rod flange and lower
flange then install nuts and washers. Note diaphragm shoulder on
top. See page 49 for tightening torque.
DIAPI iRAGM
vi 1, /k:E6RE
2. Apply NLGI #2 general purpose grease to connecting rod bearing.
3. Rotate crank arm to bottom by pulling the recoil starter. Install
diaphragm and connecting rod into pump case then install
connecting rod with mark made during disassembly facing out.
4. Install connecting rod with hardware shown below and torque
connecting rod bolt to 40 ft-lb (54 Nom, 5.5 kg-m).
CRANK
ARM
WASHER
50