MAINTENANCE
5. Pull recoil starter slowly until diaphragm pulls up against upper
case stops.
DIAPHRAGM
Crank arm should be approximately at the angle shown below.
CRANK
ARM
6. Install lower case making sure the diaphragm is centered and not
pinched between the case stops. Tighten hardware following
torque procedure on page 49.
7. If removed, install clappet valves. Refer to page 45.
8. Install pump handle and springs.
9. Check gear box oil level and fill if necessary. Refer to page 44.
1 O.Run and test pump for correct operation.
51