![](/images/backgrounds/160531/160531-9232x1.png)
!A hard reset erases all of the data and applications stored in RAM memory and launches Autoinstall, which
Hard resets automatically launch a soft reset as part of the boot process if there are CAB files present.
1.Press and hold the Reset button and then press and release the Power button. The screen turns white and the decode and scan LED flashes red for approximately three seconds.
2.The terminal
Note: Set the time and date after each hard reset to ensure that the system clock is accurate.
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend Mode. The terminal is programmed to go into Suspend Mode automatically when inactive for a specified period of time. You can set this time period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key to wake a suspended device unless the battery door has been removed and replaced.
Note: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the Main Battery Pack on page
If the terminal does not wake when you press the Power button, the main battery might be too low to resume operation. To check, remove the battery and install a fully charged battery or connect the terminal to a Dolphin charging peripheral.
Changing the Memory AllocationYou can adjust file storage vs. program memory in System Properties.1.Tap Start2.Move the slider to adjust the memory allocation and tap OK. The changes take effect immediately.
3 - 16