Bottom Panel

For details on how to mount the Net Base, see Mounting the Net Base on page 11-6.

Serial Number and Compliance

Label

MAC Address Label

Power

The terminal requires 12 Volts DC input for communications and battery charging; the power adapter on the power cable converts the voltage from the power source to 12 volts DC. Only the Honeywell 12V/ 8.5A power supply provided with the Net Base converts the voltage appropriately. The operating temperature range is -10° to 50°C (14° to 122°F).

Honeywell recommends that you leave the Net Base connected to its power source at all times, so that it is always ready to use.

!We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the Net Base

A/C Power Cord

LED

 

Power

Adapter

Power Connector Cable

1.Plug the A/C power cord into the power adapter.

2.Plug the power connector cable into the power connector on the back of the Net Base.

3.Plug the A/C power cord into a standard wall outlet. The LED on the Power Adapter illuminates to indicate power.

4.All four Power/Dock LEDs illuminate solid red to indicate the base has power. Terminal wells with properly docked Dolphins indicate power with a green LED.

5.The base is ready to begin charging terminals.

11 - 4