Installation
Keyboard Wedge
1.Turn off the host system.
2.Disconnect the keyboard from the host.
3.Connect the PowerLink cable to the 2nd jack from the top of the 7600.
4.Connect the “Y” end of the PowerLink cable to the keyboard and the keyboard port on the host. If necessary use the male/female adapter cable supplied with the scanner for proper connections.
Before continuing verify that the PowerLink cable is connected to the appropriate interface jack on the scanner. An incorrect cable connection can cause communication problems or potential damage to the scanner.
5.Connect the external power supply to the power jack on the PowerLink cable.
6.Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet.
7.Connect AC power to the transformer. The outlet should be near the equipment and easily accessible.
Figure 15: Keyboard Wedge
Interfaces
Load Keyboard
Wedge Defaults
8.Scan the Load Keyboard Wedge Defaults bar code to configure the 7600 for Keyboard Wedge communication.
³ 9 9 9 9 9 4
9.Turn on the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No.
12