RS232 or Light Pen
1.Turn off the host system.
2.Connect the PowerLink cable into the 1st jack down from the top of the 7600.
3.Connect the other end of the PowerLink cable to the host.
Before continuing verify that the PowerLink cable is connected to the appropriate interface jack on the scanner. An incorrect cable connection can cause communication problems or potential damage to the scanner.
4.Connect the external power supply to the power jack on the Power Link Cable.
5.Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet.
6.Connect AC power to the transformer. The outlet should be near the equipment and easily accessible.
7.Scan the appropriate bar codes
on page 17 to configure the 7600 for
8.Turn on the host system.
Figure 19: RS232 or Light Pen
Interface
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No.
16