Wall Mounting

You need to purchase two wall mount kits that each contain:

•a mounting bracket,

•three screws, and

•six washer/nut sets.

You need two kits so that you have two mounting brackets–one for each end of the device–and enough screws (4) and washer/nut sets (8).

The mounting bracket contains an open slot between the back and bottom wedges to accommodate the connector cables.

To Mount

1.Attach the mounting bracket to the wall using the Recommended Hardware (see page 11-8).

2.On each end of the base, insert a screw into the round end of each of the 4 screw slots on the bottom panel. Then, slide each screw towards the narrow end of the slot until it snaps in place.

3.Use a washer/nut set on each of the 4 screws to secure the screw in the slot.

4.Place the base on the mounting bracket; match the holes up with the secured screws.

5.Use the remaining washer/nut sets on each of the 4 screws to secure the base to the mounting bracket.

Recommended Hardware

If a metal or wood stud is present, drill a 3/32 in. pilot hole into the stud and use a #6 X 1 1/2 screw and washer to attach the bracket to the wall.

For any of the screws positioned so that they are going directly into dry wall, use a sheet rock anchor/ screw set such as the one listed below.

For any of the screws attaching directly into concrete, drill the appropriately sized pilot hole into the concrete and secure the bracket to the wall using concrete anchor screws such as those listed below.

Wall

Recommended Anchors

 

 

 

 

Sheet Rock

Buildex E-Z Anchor Stud Solver Medium Duty Drywall Anchor (Model #25216);

 

supports 50 lbs., screws included

 

 

Concrete

Buildex TAPCON concrete anchors 3/16 in. X at least 1 in.

 

 

11 - 8