|
|
|
|
|
| TROUBLESHOOTING THE CMR707 |
|
|
|
|
|
|
|
Symptom |
| Remedy |
| |||
Blank Display (Power Loss). | Check batteries are installed by removing the battery | |||||
|
|
| cover. |
| ||
|
|
| Check batteries have been installed in the correct | |||
|
|
| orientation. |
| ||
|
|
| Replace the batteries. | |||
|
|
|
|
| ||
Display shows flashing | The batteries in the thermostat are low on power | |||||
symbol. |
| - Replace the batteries. | ||||
|
|
|
| |||
Display shows |
| symbol. | A fault has occurred in your heating system. Remove | |||
| ||||||
|
|
| and | |||
|
|
| If the |
|
| symbol does not clear after a few minutes |
|
|
|
| |||
|
|
| contact your installer. | |||
|
| |||||
When setting my program the | The time period has been disabled, to enable see | |||||
following is displayed | ‘Disabling / Enabling Time Periods’ on page 4 | |||||
|
| |||||
The symbol is displayed but the | This may be due to the internal controls of the boiler. | |||||
boiler is not firing. |
|
|
|
|
| |
|
|
|
|
|
|
|
How do I change the batteries on the thermostat when they run out?
The thermostat constantly monitors the battery power level, which typically lasts for about 2 years before needing replaced. When the power
is running low a flashing symbol will be displayed on the screen. To change the batteries follow the steps in the above section (‘STEP 1: Installing the Batteries’ on page 3), replacing the used batteries with new ones in Step c. Note: While changing the batteries your program settings will be stored but you may need to adjust the time settings to be correct.
FAQ’s
How do I set one temperature for the whole day?
To operate as a simple thermostat with one temperature throughout the day, select the manual operating mode by pressing the MAN button. Adjust the temperature by
pressing the or buttons - this can be set anywhere from 5°C to 35°C in 0.5°C steps. The thermostat will continue to maintain this temperature until another operating mode is selected or the temperature is adjusted.