Anetsberger Brothers 14GS 14GU FRYER TROUBLESHOOTING GUIDE Continued, Problem, Cause, Remedy

Models: 14G 14GS 14GU

1 24
Download 24 pages 5.35 Kb
Page 21
Image 21
Manual background

FRYER TROUBLESHOOTING GUIDE (Continued)

PROBLEM

CAUSE

REMEDY

 

 

 

Main burners do not

1. Thermostat has failed.

1. Turn the thermostat control

stop burning.

 

knob to OFF. If the burners

 

 

do not quit burning, the ther-

 

 

mostat has failed and must

 

 

be replaced.

 

2. Gas control valve has failed.

2. Turn the gas control valve knob

 

 

to OFF. If the burners do not

 

 

quit burning, the gas control

 

 

valve has failed and must be

 

 

replaced.

 

 

 

Liquid shortening does

1. Low gas supply pressure [less than 6

1. Measure the gas supply pres-

not reach the desired

W.C. for natural gas; (11W.C. for pro-

sure.

temperature for frying.

pane) when all other gas-powered equip-

Contact your local gas supplier

 

ment is operating], causing reduced heat

to obtain adequate gas supply

 

from main burners.

pressure.

 

2. Low gas manifold pressure [less than 3½

2. Measure the gas pressure at

 

W.C. for natural gas; (10W.C. for pro-

the fryer’s manifold pressure

 

pane).

tap. Adjust the manifold pres-

 

 

sure (see Figure 6), as neces-

 

 

sary: [a] Unscrew (and re-

 

 

tain) the threaded Main Burner

 

 

Regulator Adjustment Cover. [b]

 

 

Use a flat-blade screwdriver to

 

 

turn the regulator adjustment

 

 

screw (clockwise to increase;

 

 

counterclockwise to decrease)

 

 

to reset the pressure adjust-

 

 

ment. [c] Reinstall, and tighten,

 

 

the Regulator Adjustment

 

 

Cover, when finished.

 

3. Loose knob on thermostat; or thermostat

3. Stir the shortening to mix the

 

requires calibration (temperature setting

hot shortening with some from

 

differs by about 10°F from measured

the lower ‘cool zone’ and allow

 

shortening temperature).

it to sit for 5 minutes. Turn the

 

 

thermostat knob until it ‘clicks’

 

 

on (causing the main burners to

 

 

flame); note the setting where

 

 

this occurs. Turn the thermo-

 

 

stat knob until it ‘clicks’ off

 

 

(causing the main burners to go

 

 

out); note the setting where this

 

 

occurs. Repeat this tempera-

 

 

ture ‘click points’ step at least

 

 

three times to ensure that

 

 

 

21

Page 21
Image 21
Anetsberger Brothers 14GS 14GU FRYER TROUBLESHOOTING GUIDE Continued, Problem, Cause, Remedy, Main burners do not