FRYER TROUBLESHOOTING GUIDE (Continued)
PROBLEM | CAUSE | REMEDY |
|
|
|
Pilot flame does not | 6. | 6. (Continued) |
stay lighted. (Continued) | the gas. (Continued) | For model 14GS, |
|
| and |
|
| Test the |
|
| by disconnecting the thermo- |
|
| couple at the gas control valve. |
|
| Then, disconnect the red wires |
|
| to the |
|
| from the gas control valve. |
|
| Reconnect the thermocouple; |
|
| next, perform the Lighting Pro- |
|
| cedure, to check whether the |
|
| pilot flame lights. If the pilot |
|
| flame stays lit, the |
|
| thermostat has failed and must |
|
| be replaced. |
|
|
| ! | CAUTION: DO NOT return |
|
|
|
|
|
| |
|
|
|
| the fryer to normal operation |
|
|
|
|
| with its |
|
|
|
|
| bypassed/disconnected. |
|
|
|
|
|
| |
| 7. Gas control valve has failed. | 7. Replace the gas control valve. | |||
|
|
|
|
| |
Pilot flame goes out | 1. Low gas supply pressure [less than 6” | 1. Measure the gas supply pres- | |||
repeatedly. | W.C. for natural gas; (11” W.C. for pro- |
| sure. | ||
| pane) when all other |
| Contact your local gas supplier | ||
| equipment is operating]. |
| to obtain adequate gas supply | ||
|
|
|
| pressure. | |
| 2. Loose thermocouple or | 2. Check and tighten the connec- | |||
| stat connection(s) on gas control valve. |
| tions. | ||
| 3. Pilot flame does not continuously touch | 3. Block the excessive air flow to | |||
| the thermocouple because of excessive |
| make the pilot flame contact | ||
| air flow around the pilot burner assembly. |
| the thermocouple. | ||
| 4. | 4. Check for, and repair, any dam- | |||
| the gas. |
| aged | ||
|
|
|
| ing. [For model 14GSU fryer | |
|
|
|
| ONLY: Press the reset push- | |
|
|
|
| button on the | |
|
|
|
| stat control. Perform the Light- | |
|
|
|
| ing Procedure, to check wheth- | |
|
|
|
| er the pilot flame lights. If the | |
|
|
|
| pilot flame stays lit, the high- | |
|
|
|
| limit thermostat has failed and | |
|
|
|
| must be replaced. ] |
19