3.Push the MORE button.
4.Push the SMPL (sample) button and the unit is now in the SAMP / MEAS / CLEAR mode.
SAMP Variable
5.Push SAMP (sample) button.
6.Push INC button (increase) or DEC button (decrease) until the display matches the desired value. The display is in minutes and seconds.
7.Push SAVE button to store new SAMP variable.
To Exit SAMP / MEAS / CLEAR Mode
8. Push DONE button twice slowly to get back into normal operation mode.
The Measure and Clear variables are programmed in the same manner, except for step five above in which you would push the MEAS or CLEAR button.
4.4 Data Logging
The Honeywell
EC-P2 software installation:
The Honeywell
Prior to your first datalogging session it is recommended that you connect the Honeywell
Data Logging with the Honeywell EC-P2:
To Start the Data Logging Session
1.Push power button to turn unit on. Wait for power up sequence to finish (30 seconds).
2.Push the MENU button.
3.Push the LOG button and the unit is now in the CLEAR / INT / START mode.
4.If the CLEAR button is available, that means there is data currently stored in the unit. If desired, you can erase the data already in the unit by pushing the CLEAR button. (If you don’t push CLEAR, each data logging session can be downloaded as a separate file).
18 | Honeywell |